I think they may have a few left. I ordered one recently. It cost $15 plus
$3 shipping. Just ask Garland to send you an over-voltage protection
circuit for the 262 power supply.
Mike N4NT@wireco.net
----- Original Message -----
From: Frank Creel <fcreel@gs.verio.net>
To: Michael O. Hyder <N4NT@wireco.net>; <tentec@contesting.com>; JEFF S
JOHNSON <aa8ve@juno.com>
Sent: Sunday, November 14, 1999 2:02 PM
Subject: Re: [TenTec] Crowbar in power supply
> Does TenTec sell this mod and if any idea how much??
> Thanks,
> Frank
> ----- Original Message -----
> From: Michael O. Hyder <N4NT@wireco.net>
> To: <tentec@contesting.com>; JEFF S JOHNSON <aa8ve@juno.com>
> Sent: Sunday, November 14, 1999 12:27 PM
> Subject: Re: [TenTec] Crowbar in power supply
>
>
> >
> > You remove the top cover from the power supply. Then look where the
large
> > red wire comes from the output connector and see if it goes directly to
a
> > small circuit board (about 1 x 2") before it goes to any other circuit
> > components. On that small board you will see a fuse and an SCR.
> >
> > If it does not have that little board, it needs one badly!
> >
> > Regards,
> > Mike N4NT@wireco.net
> > Johnson City, Tennessee
> >
> > ----- Original Message -----
> > From: JEFF S JOHNSON <aa8ve@juno.com>
> > To: <tentec@contesting.com>
> > Sent: Sunday, November 14, 1999 12:41 PM
> > Subject: [TenTec] Crowbar in power supply
> >
> >
> > >
> > >
> > > I recently read either here to somewhere in this virtual universe that
> > > some of the older T*T power supplies don't have a crowbar protection
> > > circuit. One was available as an option to install in these. How do I
> > > know if I have one in my 262?
> > >
> > > Thank you Jeff aa8ve ----- November is international Ten*Tec
> lovers
> > > month, run them every day!-----
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|