TenTec
[Top] [All Lists]

[TenTec] Ten Tec 301 and Omni VI+

To: <tentec@contesting.com>
Subject: [TenTec] Ten Tec 301 and Omni VI+
From: coates@oceana.net (Harry &Sara Coates)
Date: Wed, 03 Nov 1999 14:45:34 -0500
Hi Bob,
I can't find anything in the menu that must be set. One
problem with the 564 manual is that there is no overall
wiring/block schematic provided. Look at page 4-18 through
4-20 for the Logic board. On 4-18 in the right hand column,
the second paragraph explain the encoder operation. On page
4-20 in the upper right hand corner find connectors
98(Main), 80(Remote), and 99(Offset). Looks like connector
80 should go to the DB 25 (RS 232) connector. You also can't
find a complete pin connection for it in the manual. Here is
what I know abt it:
1   Grd                                           14    Grd
2                                                     15
Band 6   12/10m
3                                                     16
+5v
4                                                     17
Band 5   18/15m
5                                                     18
6    Phase 1    "A"                            19
7                                                     20
8    Phase  2   "B"                            21    Band
4    20m
9                                                     22
10    Band 1    160m                       23    Band 3
30/40m
11                                                   24
Band 2  80m
12                                                   25
Unused Band   4.0-5.5 mhz
13

Hope this helps some......

de, Harry Coates  WA8HC     Ten Tec forever es RTTY TOO




--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>