Tell me what your wiring scheme is, Robert.
It should work when you plug it in. There are no radio commands to
turn it on/off.
Suspect that there is a wiring error somewhere. Do you have 5 volts
where you are supposed to have 5 volts? Do you have ground where you
are supposed to have ground? Have you monitored the phase 0 and phase
1 voltage outputs as you rotate the encoder while it is connected to
the radio?
Have you verified the connections in the DB-25 connector? Check out
my webpage on the 301 and verify your wiring.
http://www.hal-pc.org/~kg5u/301.html
73,
Dale Martin, KG5U
kg5u@hal-pc.org
http://www.hal-pc.org/~kg5u
-----Original Message-----
From: Robert <bigmack@nortexinfo.net>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Tuesday, November 02, 1999 22:16 PM
Subject: [TenTec] 301 and Omni VI+
>
>Anybody got one of these working? The kit is so easy my cat could put
it
>together, but the instructions simply give me pin outs.. Is there
anything
>I should be doing to the radio itself to make the external knob work?
Some
>menu setting perhaps? I have it all wired up and plugged in
correctly, but
>it does nothing... Hmmmm
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|