If the crack is in the inside tube which fits around the shaft, you can take
a piece of a book match and wedge it in between the inner tube and the
outside of the knob. That worked fine for me.
73 de Mike N4NT@wireco.net
----- Original Message -----
From: <jreber@es.com>
To: <tentec@contesting.com>
Sent: Friday, October 29, 1999 9:19 AM
Subject: [TenTec] Replacement Knob for Omni D
>
> The mode select knob on my Omni D has a crack along 1 side of it, and I
> would like to replace it. Does anyone know if replacement knobs for older
> equipment can still be obtained from Ten Tec, or if there is another
source?
> Looking at the various rig pics on the "unofficial Ten Tec pages", it
> appears that the Omni D and Corsair, as well as a few other rigs, have
> similar knobs- but it's hard to tell from the small pictures.
>
> Jason
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|