You might want to ground the negative post of that Astron supply to its
chassis/cabinet. Will save you heartache over the years. Easiest way is to
remove insulators from the bolt and add a lockwasher on the inside after
cleaning off the paint around the hole for good contact.
Mike N4NT@wireco.net
----- Original Message -----
From: Jonesy KC9TV <tlj@indy.net>
To: <TenTec@contesting.com>
Sent: Sunday, September 12, 1999 7:53 PM
Subject: [TenTec] OMNI VI Keyer
>
> Well I found the problem with the keyer in my OMNI VI it is my Astron
> power supply. All of a sudden its got
> way to much AC ripple. I know I should have got TenTec supply but thanks
> for all who sent messages to help me.
> For some reason I never thought about power supply but after 1 min. on
> the phone with TenTec service
> dept. the problem was found.
>
>
> KC9TV
> Jonesy
>
> "9-Land the Black Hole of RF"
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|