I have recently installed the Inrad 2.4 Khz (9 MHz IF) in my Omni V.
I am experimenting with the Ten-Tec 2.4 Khz in the NAR position.
My question is where do I place the gain jumper? The manual suggests
that the 218 (1800 Hz) filter goes in one position and the 216 (??),
217 (500 Hz) or 219 (250 Hz) go in another. In contrast, the
schematic suggests that the jumper for 2.4 and 1.8 KHz is one position
and the 500 and 250 Hz is in another.
Also, what is a 216??
Thanks,
Rick Williams
VE7ASR
email: ve7asr@islandnet.com
Packet: VE7ASR@VE7DIE.#SVI.BC.CAN.NOAM
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|