> This time, had presence of mind to disconnect the PS from
> the Omni. Put in another fuse, turned on the power -- nothing,
> no pilot light. Checked the fuse, was not blown.
>
> So, obviously I made an error putting in the 10 amp fast blow
Maybe, maybe not......with the power supply disconnected from the Omni
VI, how did you turn the power supply on? Isn't there a a pair of
wires that must be connected together via the power on/off switch
located on the Omni? Just wondering, and I haven't taken time to look
at my set up this morning.
Wish you luck with it.
Jim, WD4AIR
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|