Signs seen along Dolly Parton Hgw.
If you have a new Scout
That just won't behave
Take a sharp knife
And give it a shave
TenTec
On Wed, 14 Jul 1999, Beamer, Jay wrote:
>
> Hello Bill,
>
> Yes, I do have a suggestion, and worked fine when I had problems with a
> couple modules. It is essential that the module, when pushed in, is flush
> with the front panel of the radio. Sometimes this is quite difficult. Look
> at the sockets on the module itself. There are a couple of jacks, for lack
> of a better description, on the module. Take an xacto knife and run it
> around the inside edge of those plastic jacks, just shaving off a small
> amount of plastic, then try it in the Scout. Keep shaving small amounts and
> trying the module in the Scout until you get a nice fit. That should take
> care of the problem.
>
> 73,
>
> Jay/KM6VX
>
> -----Original Message-----
> From: Bill Legge, NT1R [mailto:wlegge1@maine.rr.com]
> Sent: Tuesday, July 13, 1999 6:10 PM
> To: tentec@contesting.com
> Subject: [TenTec] Scout module problem?
>
>
>
> Hello,
> I have been using the rig on 10 meters mobile for awhile. Now I find some
> of the other modules are not making good contact. Does anyone have a
> suggestion for me? Bill Legge, NT1R in Yarmouth, ME
> QRP-L #912
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
Steve Ellington N4LQ
N4LQ@IGLOU.COM
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|