<fontfamily><param>Courier New</param><smaller>Has anyone tried to align
the BP filters and adjust the LO/Mixer in these? I was able to re-align
my BPF on a 20 meter module which was acting flaky by placing it on a
network analyzer (and I was assuming a 50 ohm in/out impedance--there is
no data on the filter impedance in the manual). My question to the group
is how to adjust the LO/Mixer given the fact it must be powered. The best
way would be in the radio, however this is not very practical. I think I
would need an extension card to bring the module out of the radio to
perform this adjustment. Anyone have any thoughts on this?
Leonard Popyack
WF2V</smaller></fontfamily>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|