(resent, due to mail problem)
Sure, just connect an antenna, apply drive and go. I've used mine often on
30. The only tuned circuits are low pass filters for each position of the
band switch so no modifications are needed. I don't have the manual at hand
so I can't tell you what the cutoff frequencies are for each band, but I
seem to remember using the 20m position for 30. I believe the cutoff for the
40m position is a little low, but you might want to check the manual for
that.
Bruce, W3GDZ
-----Original Message-----
From: Larry L. Laflamme <laflamme@ncia.net>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Friday, April 23, 1999 5:40 AM
Subject: [TenTec] 405 on 30 Meters
>
>Has anybody tried putting the Model 405 or similiar amplifier on 30
meters??
>I would apreciate any comments before I start this project.
>73
>Larry, N1SHM
>laflamme@ncia.net
>
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|