Duane,
It would appear that the month is off on your computer. Your email is now
going to live at the top of my ten-tec mail folder for the next month while
the rest of us catch up to you. HI HI!
- Tom
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
Tom Scott - Wyle Electronics - KD7DMH
10300 SW Nimbus Ave #PB, Portland, OR 97223
503-603-1931 - TEL 503-684-6620 - FAX
503-504-1583 - Cell 503-604-8651 - Pager
_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
-----Original Message-----
From: owner-tentec@contesting.com [mailto:owner-tentec@contesting.com]
Sent: Wednesday, May 19, 1999 3:57 AM
To: Tentec@Contesting. Com
Subject: [TenTec] RE: FS: OMNI VI+, 962 PS, 705 mic, filters, 238 tuner
YOU SAID:
"I have been asked about the Omni VI+ listed below. Just to clarify, it is
a
#563 that has been upgraded to #564 (Factory Option 3 upgrade).
73 de WB0LJP"
That is not correct. You cannot upgrade an Omni VI to an Omni VI+. You
have - forever - a Model 563 Omni VI, which has had the Factory Option 3
installed. It is functionally the equivalent of the Model 564, but it is NOT
a Model 564. If it were, the plate on the rear would say Model 564, and you
would have a "+" on the front.
Not a big point, but there are those two differences in the two models.
73
BUDD, K4AAE
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|