Mike,
Before you get too worried, have you tried changing modes and then
changing the band stacking??
What I'm trying to say is that the band stacking may be working
perfectly fine and you just have the SAME freq, mode, filter etc in each
register!! (Been there, done that and got myself worried for a second or
two).
Hopefully that will fix it and it will turn into a non-problem... Good
luck!
73/Carter/K8VT
Mike Hutchins wrote:
>
> Greetings All!
> Just noticed today whilst chasing 3B9R, that the Bandstacking register
> for 160m on my OMNI VI (ver 1 upgrade), ain't working. There is no
> reaction at all when I push the bandswitch a second time, no matter how
> long a delay I leave between pushes! 160m is fine otherwise, as are all
> the other bands - where bandstacking is normal.
> I'm assuming bandstacking is done through the firmware & there is
> nothing I can do myself about the problem - any of you had the same
> problem? any ideas?
>
> Thanks & 73!
> Mike, ZL1MH
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|