Hi Tim,
I found that my Paragon I needed a pullup resistor for use with
a Kantronics KAM. The KAM FSK outout is an "open collector" and
the Paragon needs 0 to -15 V for mark and +2.5 to +15 V for space.
I wired the AUX 12 V jack through a series resistor and a short
piece of wire to the mark/space plug on the back. This was done
externally so that when I plug in the FSK line from the TNC, I alos plug
the pull up line into the 12 V jack. I used a 16 K resistor bwecause it
was handy, but anything from 10 K to 22 K should work.
73, Bob WB2VUF
Tim Cook wrote:
>
> I am going to be setting up my Paragon and PK-232 for the digital modes here
> soon, and I seem to recall from doing this years ago, there might be a mod
> needed to the Paragon's mark/space input. I can't seem to find anything in
> the manual for the radio or the pk-232. Does anyone recall this mod? I
> think it had to do with putting in a 'pullup" resistor on the input
> jack??????
> Thanks
> Tim
> NZ8J
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|