Thanks to all for all the great suggestions on my Argo Drift and jumpy power
setting.
I replaced the var resistor with the same value from RS and it works just
fine. As far as the drift and funny tunning goes, I fixed that do in a very
weird kinda way.
I pulled the VFO knob off and looked down inside to pto, I kinda gave it a
push up and to the right not much of one, with very little force (may not
have done anything) Put the VFO knob back on, before I had noticed that it
was just touching the case of the radio, this time I left a much bigger gap
between the knob and the case, now the tunning works GREAT!! Just like
described in the manual.
Thanks again for all your help...
73,
Jim -- KC4SMH
fielden@utkux.utcc.utk.edu
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|