At 01:07 PM 3/8/98 -0600, CHARLES R COUCH wrote:
>I just brought an Omni 5 that works great except for the
>hum that's coming from the model 961 p/s speaker.It's hard
>to tell it's there when there's a signal present,but when
>I turn the volume down you can hear it very well,also It is
>so loud when you use headphones it makes it IMPOSSIBLE
>to use them.The volume control does not affect the hum.I'm
>going to try my Kenwood p/s today to see if it goes away then.
>Has anyone else run into this before?
>
> THANKS
> ROBERT/N4USG
Robert, try putting the power supply on the opposite side of the rig.
My paragon had same trouble when I had the supply on the right side
of the rig. Don't know if that is the trouble but I know many people
including myself cured a hum by doing that. Good luck....Steve
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|