I would definetly be interested in a 10 (or more) pole SSB filter to put
into the first IF of the TT Omni series. This is the point where
selectivity does the most good anyway. Ideally, the filter should be 2.0
or 2.1 KHz wide and properly centered to leave some low frequency
response in the received signal. Then I can use my 1.8 KHz TT filter in
the 6.3 MHz IF to narrow things down when the going really gets tough.
My two cents...
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|