Hello Mike,
I have a 229B, which is electrically identical to the 238. I purchased it used
from Ten-Tec. The comment on the slide rule indicator is correct. I wish it
were a counter. There are no rivets. All connectors are secured with
screws/lock washers/nuts. I regard the review as harsh. However, if your
using 100-150 watts out, you might consider the autotuner AT-11 by LDG.
73,
Mike KF2LF GO PACK!
-----Original Message-----
From: Lara & Mike Pagel [SMTP:pagel@wi-net.com]
Sent: Sunday, January 18, 1998 6:05 PM
To: tentec@contesting.com
Subject: [TenTec] 238 tuner on 160? (long)
Hello all:
I'm looking for a tuner, one that will enable me to cover more of 160
meters with my dipole and CTSVR antennas. I have been thinking about
pouncing on one of the #238 tuners that pop up here from time to time.
While waiting, I dug up the review of tuners in the March '97 QST. No
TenTec there, but coverage on 160 seemed to be a problem for most of the
commercial products reviewed, unless you were willing to spend a grand or
so. Frankly, I was hoping to spend much less.
I then reviewed the archive for the TOPBAND reflector and read messages
associated with that same QST tuner review. There seemed to be a strong
anti-MFJ sentiment, but significant disagreement about what was better.
Someone favorably mentioned the #238, and that message was answered by
another ham who offered an unfavorable analysis - mostly about the
hardware.
Here is a portion of his message about the #238:
==========================================
I don't like:
* the anemic range (capacitor) switch--a conventional ceramic wafer easily
destroyed by a hotswitch at moderate power.
* the roller inductor--the coil form is ceramic, and the coil has a
variable pitch, but the end plates are epoxy/glass PC board, and the roller
tap wheel is skimpy. I wore mine out (the tap wheel literally wobbled on
the shaft) and replaced it with a roller inductor and counter mechanism
from a BC375E.
* the sliderule dial mechanism--I repaired it countless times until I just
threw it away, and it was not readable without the dial lights--nor was the
meter.
* the SWR/power meter--very inaccurate and nonlinear. Good for relative
indication only.
* the case--typical TenTec. Frequent disassembly lunched the end trim
pieces--I threw them away. Coax connectors were pop-riveted, but worked
loose over time, creating intermittent ground connections. Replaced all
rivets with screws, starwashers and nuts.
* the balun, a 4:1 unit. Most baluns in single-ended tuners---if not
all--are useless unless operated near the design center. This one smoked
early on, and I tore it out. If you want to use balanced line, build a
balanced-line tuner.
General construction reminds one of a homebrew project--useable but
cheaply-made couplings, shafts. knobs and other components. In short: good
electrical concepts, mediocre execution. This unit has helped dissuade me
from buying other TenTec gear.
======================================
My question is - are these comments valid?
Are any of you running the #238 on 160? What are your experiences? I'm
running only 100 watts but have managed to work 31 countries from the RF
sinkhole that is the upper midwest, and a good tuner might help me work a
few more. Someday I might even buy an amp!
I'm told that Ameritron builds a good tuner, but the skimpy literature I
find seems to imply that it lacks a roller inductor and I'm assuming that
I'd prefer the roller type to the tapped variety. Dentron, according to
local legend, also built a good tuner but no one I've spoken to actually
owned one.
Suggestions?
73, de Mike, K9UW
Amherst, WI
pagel@wi-net.com
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|