Hello,
I'm not seeking help from Ten Tec's service department. Let me make that
clear from the start.
However, I have a problems which continues to occur on an Argosy SWR/S meter.
It seems to warp when it gets hot and bend at one upper edge. This causes the
meter to stick when a signal hits S-9.
I'd like to know how to get into the rig and bend the little devil back again.
The rear of the meter seems sealed tightly and I hate to pry it off. Does the
front plastic pop off the meter section?
I can't send it to Ten Tec every time it starts to stick. I'd be shipping the
dickens a lot to Sevierville.
Just thought somebody would know.
73s,
Rick
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|