Ten-Tec, Inc. wrote:
>
>
> The VOA will be broadcasting a 30 minute long segment on Ten-Tec,
> shortwave receiving and the 1254 receiver kit tomorrow, Saturday
> Nov. 22 during their "Communications World" radio show.
>
> VOA suggested listening on 5985 kHz at 1030 UTC, 7768.5 kHz at 1230
> UTC, or 15120 kHz at 1730 kHz. There are many other additional times
> and frequencies that are used by them as well "as announced".
>
This broadcast actually was on Saturday 11/22. Unfortunately my ISP was
not letting me transmit outgoing e-mail on Friday and the message did not
go out until Monday morning. I do not know if VOA is planning to
re-broadcast and we do not have a tape of the program.
-----------------------------------
WB2TPS wrote:
>(Travolta uses a Paragon, copies AMTOR by ear)
>So, I tried to send RTTY and AMTOR with a straight key on my OMNI-VI
>( the TNC was off)....no luck!!!
>
>Do you think TT will include this amazing capability in a future
>firmware upgrade for the OMNI???
We're working on it as we speak, and we'll also be adding a DISCO function
to the menu system to allow playback of Lee Ritenour's guitar licks from
the Saturday Night Fever album through the rig's speaker.
You guys are the best ! Thanks for your support of Ten-Tec.
Ten-Tec will be closed Thursday 11/27 and Friday 11/28 for Thanksgiving.
73,
Scott Robbins, W4PA
Amateur Radio Product Manager
---------------------------------------------------------------------
Ten-Tec, Inc., 1185 Dolly Parton Parkway, Sevierville, TN 37862 USA
Contact Mon-Fri Eastern time: Office/Tech (423) 453-7172 9 am-5 pm.
Repair (423) 428-0364 8 am-4 pm. Sales (800) 833-7373 9 am-5:30 pm.
Fax (423) 428-4483 24 hrs. E-mail <sales@tentec.com> for sales and
general product info only. We presently do not offer repair or
kit building tech support by electronic mail, please telephone.
Visit us at <http://www.tentec.com>
Ten-Tec manufactures amateur radio equipment, military and commerical
use HF radio equipment, custom aluminum and steel enclosures and has an
on-premises, fully equipped tool and die facility supplying the metal
and plastic injection mold industries. Potential tool and die, custom
enclosure or communications electronics customer? Contact us.
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|