>I received this from TenTec
> QRP MOD for CORSAIR 1, II (560,561)
>Materials Needed:
> 1 -2.7 to 3. Volt Zener diod OR 4-1N4002 diodes
> 1 - toggle switch
> 6" Hookup wire
>The purpose of this modification is to allow the Corsair transciever to
>operate QRP. This can be a permanent change or only as a temporary
>change.
>
(snip)
I find no problem simply using the drive control to reduce the output
power when using the rig for QRP cw. The power will go as low as you
like.
--
72, Peter G3XJS ( http://www.barville.demon.co.uk/qrpinfo.htm )
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|