Bill W1PA wrote:
> - Glad to see Ten Ten installed a crowbar in the supply
> (versus my old Omni stock supply). Question: if there is
> a SCR over-current check in the supply, and a fuse at the
> rig, why is the additional 1140 breaker recommended?
Hello Bill.. The breaker is recommended only for use with a non-TenTec
supply or battery (page 2-1 of my Corsair-2 manual).
The 961's fuse is on the AC side of the power supply, for power supply
protection against internal component failure or gross overload.
The over-current circuit is on the output side of the supply, and reacts
much faster than the AC line fuse could to protect the Corsair PA. Check out
the manual pages 2-13 thru 2-16 for interesting info about Ten Tec designs
and why they need the fast over-current protection.
73 -- Glenn
----------------------------
"Remember, any tool can be the right tool!" Red Green
AE0Q / V31RY ex: GM5BKC, ZB2WZ, SV0WY, WA0VPK
v31ry@ix.netcom.com --SOWP 5558-M, ARRL LM, QCWA LM, NCVA--
http://www.qsl.net/ae0q
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|