I have a Scout and would like to install a pad at the audio jack to allow
use of 8 Ohm stereo headphones. Any recommendations out there for the
component values and installation techniques? The manual just says to
install a pad, but gives no suggestions. I've done this mod on other Ten
Tec rigs (Century 21, for example) but wonder if there is anything that I
should know about before putting the Scout under the knife. I think I've
seen this information posted before, but couldn't find it during a one-hour
search of the archives. Please forgive me if this thread has gone through
the needle before.
73s,
Dennis, NX5W
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|