Landen,
There is none on the Paragon. The Tuning knob attaches directly to the shaft
of the Hewlett Packard encoder. All the resistance is in the inertia of the
knob and the bearings in the encoder. I took and put a 'drop' of light
machine oil on the shaft bearing and it made it even more silky smooth.
At 01:45 PM 7/16/97 PST, you wrote:
>Does anyone happen to know if their is an adjustment on the VFO knob, to
>adjust the
>spinning tension on a Paragon and OMNI V?
>Thanks
>Landen Stoker KC5QDZ
>Email KC5QDZ@JUNO.COM
>
I hope this helps,
George V73GT
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|