>Paragraph should read:
>
>Identify shielded coil L12, .....
>..... VERY
>IMPORTANT: also solder the shield tabs to the top ground plane.
Many thanks to Chuck Adams for pointing out the correct step.
Turns out the topside solder supplement in the manual also stressed to
solder the cans of three coils to the top ground plane, including L12.
I'm going to pencil in the corrections where need be...
I see I have two more messages in the inbox. Thanks for the help,
folks!
--Andy
wallace@world.std.com
---
Curly: Oh....short wave?
Moe: No! Poimanent.
<BONK!>
(THEY STOOGE TO CONGA, 1943)
--
FAQ on WWW: http://www.contesting.com/TenTecFAQ.html
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
|