I am trying to use my IC-751A and Hercules 444 but they do not seem to
get along together.After doing what the manual says for both Icom
and Ten Tec doesn't work.After correct hookups and running 35 watts of
drive, Hercules amp trips out and status light over drive comes on.
Does this with 10 watts also.SSB,VOX and CW mode.This is how I have
it connected.
(1) outside antenna to amp marked antenna.
(2) amp marked transciver to 751A output.
(3) ten tec relay line to icom relay
this should be the T/R line
(4) alc to alc (5) then grounded
this is all it list for operation.Any ideas would sure help.
thanks
73s/mr
--
FAQ on WWW: http://www.contesting.com/TenTecFAQ.html
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: w9tw@contesting.com
Sponsored by: Akorn Access, Inc & N4VJ / K4AAA
|