At the request of several people, I am posting a summary of positive
responses to my original message below. All programs mentioned have
a WWW page and have a demo version available. I have not personally
evaluated or compared and do not personally endorse any of the
software. The following comments were provided by other readers of
this reflector:
1. DxBase, as the name implies, is oriented towards the DXer. It
almost
fully supports the Omni V in sending to and receiving information
from
the V.
http://www.mindspring.com/~jlennox/
2. Log-Eqf is more of a general logging program with the ability to
track
DXCC and handle contests. Log-EQF will retrieve frequency and mode
information
from the Omni V. It will also change bands.
http://www.itis.net/eqf/
3 DX4WIN is a full featured logging program and will allow the user
to
configure his own radio driver.
http://home.erols.com/pvander/
The OMNI V protocols can be obtained from Ten-Tec or several readers
of this reflector.
73...
Don Whitener, K4BWU
whitener@hiwaay.net
----------
> From: Don Whitener <whitener@hiwaay.net>
> To: TenTec Reflector <tentec@akorn.net>
> Subject: OMNI V Rig Control
To: <tentec@contesting.com>
> Date: Tuesday, January 28, 1997 4:17 PM
>
> The OMNI V has a degree of rig control possible via the rear panel
> RS-232 connector, but it would seem that none of the popular
logging
> programs support the OMNI V. I would seem to me that it would be
> possible to write a translator program, perhaps operating as a TSR,
to
> convert commands and status from one of the standard rig sets to
the
> OMNI V set. Does anyone know if such a translator has ever been
> written?
>
> For that matter, does anyone know of any available software for
> controlling the OMNI V?
>
> 73...
> Don Whitener, K4BWU
> whitener@hiwaay.net
>
--
FAQ on WWW: http://www.contesting.com/TenTecFAQ.html
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: w9tw@contesting.com
Sponsored by: Akorn Access, Inc & N4VJ / K4AAA
|