On Sun, 14 Jan 1996, Victor A. Dubois wrote:
> I just purchased one of the DVP boards from LZ engineering and will hook it
> up to my OMNI VI when it gets back from a visit to the factory for a minor
> tune up. Before it gets back I have several questions to those of you who
> have used DVP boards before.
>
> First is any special software needed to make it run other than CT or TR ? I
> have both CT 9 and TR so I might be set as far as software goes.
DVPTSR.EXE is shipped with TRLog and CT. It is also available by FTP.
DVPTSR takes care of the DVP and each of the logging programs simply send
commands to the TSR.
> Second is it possible to hook up the DVP board to the computer and test it
> out before the OMNI is back from TEN TEC, or must the rig be in line test it ?
You could hook it up to another radio. You can make recordings and play
them back in your headphones.
> Finally, any suggestions or hints you can give a NON PHONEY operator as to
> installation of the DVP board if any would be appreciated. Especially if I
> should be aware of any tricks needed to get it working.
Follow the directions. It's trivial.
Bill
---------------------------------------------------------------------------
Bill Fisher, President | bill@akorn.net | Atlanta Internet Access |
Akorn Access, Inc. | http://www.akorn.net | and WWW Services. |
770-569-1550 | | |
---------------------------------------------------------------------------
|