At 07:24 AM 11/27/2007, WG0M@aol.com wrote:
>Help
>I am running 6.79 Post and before I delete and replace it with 6.88 I
>thought I would try 6.88 Post. It failed to start. I received the
>following
>error:
>
>Stub error (2002); can't find rtm.exe
>
>
>Any ideas?
>
>Michael WG0M
Hi Michael -
Here is a response from Tree to an earlier message with that same problem:
On Wed, May 30, 2007 at 04:23:15AM +0000, bob hervatine wrote:
> Now when I attempt to run Post, I receive the following error message:
>
> 'Stub Error (2002): can't find rtm.exe'
>
> Any suggestions/advice?
This is my fault. I compiled the POST program in a different mode - that
allows you to use more memory - but requires two program to make it
work. rtm.exe and dpmi16bi.ovl. I just put these up on www.kkn.net/~tree
and you can download them. Put them where POST.EXE is and it should work
fine.
Tree
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|