Hank,
In answer to #1 there is a flag that you set (in Ctrl-J) to show S and P q's
versus running q's. Also a flag to set to show on which radio the q was
made. Also you can record the frequency of each q but in some contests if
you do this then you don't have the q number shown in the final log. Not
sure if this is the case in SS or not but I do know it is for sure in the DX
contests.
On #2 I doubt this is possible.
On #3 not sure but doubt it.
Mike W9RE
-----Original Message-----
From: trlog-bounces@contesting.com [mailto:trlog-bounces@contesting.com]On
Behalf Of Hank Garretson
Sent: Thursday, November 09, 2006 1:55 PM
To: trlog@contesting.com
Subject: [Trlog] Wish List/Help
I used 6.79 for SS CW, and have some wishes. Or maybe I just need
some suggestions to change my TR configuration.
1. It would be nice to have a log flag indicating whether the
contact was CQ mode or S&P mode. Alternatively is there a way to
have the frequency for each QSO be the radio frequency instead of
generic band frequency? If so, one could get a pretty good idea
which mode you were in.
2. It would be nice to have the F-key descriptive line at the bottom
of the screen, just above the keyboard. This was the first time I
used the band window and the F-key line was relegated to above the
band window. Is there a way to put it at the bottom of the screen?
3. It would be nice to have a non-ambiguous screen indication when
in the S&P mode. Usually the message is there. But when I hit space
to check for a dupe, and it is a dupe, the You-are-in-S&P-mode
message gets replaced by Kxxxx-was-a-dupe message. Is there someway
to have these two messages in separate places?
73,
Hank, W6SX
Mammoth Lakes, California
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|