Re: [Trlog] DVP board

[Ken Beals <k6mr@pacbell.net>]

Thanks to all for the notes that DVP boards should work just fine.  I 
guess I wasn't sure how many people were still using them.

Bottom line is it turned out to be connection error.  I swapped a couple 
of grounds, and when I plugged the DVP output into the radio, it caused 
the problem.  I didn't have it connected to the radio when I tried CT, 
since I just used the monitor function.  Speaking of which, now I guess 
I have to figure out a way to monitor the thing, since my K2 doesn't 
have a monitor function.  And, there seems to be a bit of RF feedback, 
but some beads and toroids will hopefully take care of that. 

Tree:  I could not get the hot keys to do anything even with changing 
the USE BIOS CALLS parameter.  Are they supposed to work? 

Ken

Tree wrote:

> On Sat, Jun 05, 2004 at 11:43:30PM -0700, Ken Beals wrote:
>
>  
>
> > Anybody out there using a K1EA DVP board?  Thought I'd try it out during 
> > field day.  The board seems to work just fine under CT.  When I run it 
> > under TR, the output audio level is very low.  It seems like when DVPTSR 
> > loads, it defaults to minimum audio level.  Alt-up arrow doesn't do 
> > anything (not that I expected it to), and I can't find anything in the 
> > manual that points to a hot key to increase the audio level.
> >    
>
> Hmmm - I have not had that problem with mine.  Is the audio level okay
> for either playback (previously recorded) or live?
>
> You might be able to enable the hot keys by using the option to use
> the BIOS for the keystrokes.  I think the Control-J parameter is 
> USE BIOS CALLS or something like that.
>
> Tree
>
>  

_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog