And there's your problem. The FT-1000MP uses a non-standard configuration.
It is straight through, not crossed: Pin 2 goes to Pin 2, 3 to 3, and 5 to
5. And it's F to F, not the more typical "modem" M - F.
73 de Bob, K6XX
k6xx@k6xx.com
> -----Original Message-----
> From: trlog-bounces@contesting.com
> [mailto:trlog-bounces@contesting.com]On Behalf Of Pete
> Sent: Monday, November 10, 2003 9:51 PM
> To: trlog@contesting.com
> Subject: [Trlog] CAT Problems
>
>
> New PC motherboard and new FT1000 MK V. Trying to get CAT going from
> Com 2 to XCVR.
>
> I made up a DB9 serial cable with the send/rcv reversed on one connector.
> as I have about run out.
>
> 73 Pete N4KW
>
>
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|