Same problem here.
Jon Hamlet, W4ZW
Casey Key Island, FL
"A little bit of Paradise in the Gulf of Mexico"
*-----Original Message-----
*From: trlog-bounces@contesting.com
*[mailto:trlog-bounces@contesting.com] On Behalf Of Bob Lafont
*Sent: Monday, November 03, 2003 9:58 PM
*To: TRlog
*Subject: [Trlog] Exchange Window
*
*
*I noticed in SSCW last weekend that after entering a callsign
*and hitting the enter key, in either run or S&P modes, the
*cursor went to the exchange field but one character spacing to
*the right in the field. In other words, when moving to the
*exchange field there was a space to the left of the cursor.
*This was not a problem most of the time but occasionally when
*finishing the QSO and hitting the enter key the exchange field
*information overwrote the callsign in the call field. To avoid
*callsign from being overwritten I would manually move the
*cursor one position to the left in the exchange field when
*moving from the callsign field to the exchange field.
*Overwriting of callsigns stopped at that point.
*
*Was the behavior of the cursor moving one space to the right
*in the exchange field a setup issue or a problem with the program?
*
*The same question applies to the exchange field overwriting
*the callsign as well.
*
*Thanks
*
*73-Bob
*WA2MNO
*
*_______________________________________________
*Trlog mailing list
*Trlog@contesting.com http://lists.contesting.com/mailman/listinfo/trlog
*
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|