On Sun, Aug 03, 2003 at 02:00:41PM -0400, KZ5D@aol.com wrote:
> How can I delete the auto zero of the clarifier whenever you send a CQ with
> TR? This is an annoying problem since I happen to listen about 20 hz up from
> my
> transmitted signal.
Remove the > character from the CQ Message.
> Is there any way to set the program not to allow access to the same bands
> when using SO2R? Just getting used to this neat system, but found myself
> jumping
> the run radio onto the second radio's band in the NAQP. Not too good for the
> second radio's RX.
SKIP ACTIVE BAND = TRUE
>
> After the contests, I noticed an optin under Control J about "Total Time
> Off." I haven't seen any documentation about it, so any idea what this does?
Not much - I gave up on the time off feature years ago.
Tree
|