i've been a bit behind on updating versions. i just put up 6.72, and when
i first start up tr log, it reads and displays the frequency and mode
correctly once, then never more. if i change band, mode, or freqency,
that is never reported by tr log. i can command the radio to change
freqency, and it responds, but that is about all. i tried varying 'icom
command pause' and 'icom response timeout' without any success. i don't
have the 6.71 versions in my inbox for some reason, but if i go back to
6.70, the omni works. looking with a scope, both the txd and rxd lines
are going like crazy - all the time.
i seem to be having more problems than other omni users reported. i'd
appreciate any feedback on settings you've changed from the default. i am
running an old, slow, ibm thinkpad 760el with the default baud rate of
4800. thanks.
73, john
http://www.kkn.net/~ke5c/
|