On Mon, Feb 17, 2003 at 09:48:11AM -0800, paule@sfu.ca wrote:
> First the good news. Some will remember my reporting clock issues.
> I had a chance to narrow it down. It seems that if a radio is specified
> for a port, but either not on, or not connected, the clock display is
> irratic. If the rig is connected and on the display is normal.
I have seen the same thing with my TS850 as a second radio. If it is off,
the clock only updates every 2 seconds or so. Normally, not an issue, but
it is a small pain when using the auto-cq function.
> Now the bad news. For some reason, with 6.72 when tuning in a signal
> with a ts940 (same problem with three of them) the audio changes in about
> 10hz steps rather than a smooth transition. The problem goes away
> when 6.69 or 6.68 is reinstalled. I suspect the higher polling rate
> on the serial port has something to do with it.
Haven't heard that on the 850. Perhaps the normal poll rate should be
the "default"?
Tree
|