At this point in time only the Omni VI is supported by TR. I did
download the Argo manual and will put that support in the code at some
point. I am waiting for some documentation from TenTec to handle some
quirks in the Omni VI firmware (different version act differently!).
They also owe some information on the Orion. They have not yet released
it beleive it or not. I probably will not be adding other TT support
until I get the VI squared away.
Floyd Smithberg wrote:
>
> I have software from N4PY installed in my laptop to control my TenTec Argo
> V.
> and they work well together....change band, freq, mode, filters, etc.
> . But when I open TR and try to control the Argo from TR....can't get TR
> to communicate with the N4PY program. Tried various logcfg commands
> but no luck. N4PY says, use Pegasus setup but results are the same.
> Any suggestions? TIA
> 73 Floyd NQ7X Phoenix,AZ DM33VQ
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
--
73 es God Bless de KK1L...ron (kk1l@arrl.net) <><
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l
|