I have the same difficulty in moving from CQ to S&P (if I end up in CQ mode
by accident). Invariably I'm inexperienced with the program and somehow end
up in CQ mode by accident, and the shift key moves me around after hitting
shift-tab to move back to S&P mode.
I ended up turning it off, but may turn it back on when I get more
proficient.
On a side note, a coworker has a licence plate that reads ALT TAB. Wonder
if that means back up? :)
de N5NW (Marty)
Bellbrook, Ohio
-----Original Message-----
From: trlog-bounces@contesting.com
[mailto:trlog-bounces@contesting.com]On Behalf Of Mark Beckwith
Sent: Monday, February 03, 2003 11:33 AM
To: trlog@contesting.com
Subject: [Trlog] Shift Key woes
I notice that TR log thinks when I hold down Ctrl+Shift (to key down) if the
shift key hangs over (which of course it does), it begins tuning the RIT.
If it would be easy to program, could perhaps the [RIT-moving-routine] check
to see if the Control key was pressed any time in the last few milliseconds?
Or whatever that check would be. That would end this problem.
Mark, N5OT
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|