Ken,
Maybe you missed my previous post on this
1. Program an F Key to send the A<>B command to the radio. (i.e. swap
VFOs)
e.g. F9=<03>SRS1=xxx<01><05><04>. Do this for both the CQ and
Exchange memories. (Avoids problems if TR switches to S&P mode when you
change VFO freq)
2. Put this command in stdcfg.dat (This will program the F9 key for
you every time you run TR.)
3. When you want to QSY the B VFO
a. Hit F9. This will swap the VFOs.
b. Type in the frequency and hit ENTER. The A (formerly B) VFO will
QSY as desired.
c. Hit F9 again and, voila, A is back where it was and B is where you
want it.
I've tried it on my MkV. It works.
73 de Jim Smith VE7FO
Ken Adams K5KA wrote:
> The following command string will send the sub vfo to 14.056.10
> and NOT put it in split mode when you press F9:
>
> F9=<03>SRS=<10><56><40><01><8A><04>
>
> Not acually useful until we can enter the freq from the keyboard
> or etc. but at least there is a command to make it happen.
>
> Ken K5KA
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog
>
|