Hi Gang,
I thought that I had the disk partitioning down to a science using
Partition Magic and Boot Magic. I had 4 nice primary partitions. One each
for the Dell hidden system (FAT), DOS (FAT), 98 (FAT32) and XP (NTFS).
Boot magic allows me to easily boot to any of the latter three. A copy of
TRLog 6.64 resides on each partition.
BUT, when I try to run TRLog while in native DOS 6.2, the program simply
stops accepting keyboard commands after about 5 keystrokes! The setup
routine is OK. I can use CTRL-J to make a change or two, but when I go to
log a Q, the keyboard seems dead. The cursor in the call entry field is
blinking as it normally does. At this point the only thing that works is
removing the AC power and the battery and rebooting. A search of the
archives did not solve my problem. HELP!
For the ARCI contest over the weekend I had to load QRPDupe and run it out
98. It's a darn nice program, but I WANT TRLog BACK.
73, Mark K2QO
Mark S. Adams, P.E.
University at Buffalo
Occupational and Environmental Safety
220 Winspear Avenue
Buffalo, NY 14215-1034
Tel: 716.829.3707 ext. 25 Fax: 716.829.2704
Pager: 716.774.2260
|