In setting up my config file for the NAQP contest this weekend, I noticed that
I was not prompted for the NAME and QTH parameters. These were included in my
INPUT CONFIG FILE but the software did not pick them up. I relocated that line
to just above the CONTEST NAME and all worked well. I have always had the
INPUT CONFIG FILE line after the CONTEST NAME w/o any problem.
QUESTION: I am able to set up my CQ QSL message to send TU <name> thereby
confirming good copy of the name sent. However, in my S&P EXCHANGE, I used the
same protocol and it does not pick up the name entered when I copied the
initial exchange. I presume this info has alread been flushed out by the time
I hit the ENTER key. Is there a way around this?
=*=* ==*= =** =**= =** * =*= =**** =*= =*== *===
Ron Angle, Chico CA
73 de K6KYJ [From the Land of the Seven Dipoles]
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|