----- Original Message -----
From: <k6ll@juno.com
<snip>
>
>
> Using the software that came with your Kantronics, set the tnc
> baud rate at 2400, then exit the program. The tnc remembers its
> last baud rate setting.
_________________________________________________________
Only the newer versions of KAM tncs automatically remember their settings.
Older ones have to have the PERM command executed before turning them off,
otherwise they revert to the previous setting. I have a version 5 which
requires PERM; I know version 8 does not... where the change was made, I
don't know but it was in there somewhere. The difference is the later ones
have a battery for memory backup and the older ones used an EEPROM with no
battery.
Anyone who owns a KAM probably knows this already, but I thought I'd clarify
it for possible future owners.
Bill, W7TI
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|