************************************************
repeat post of a message returned as undeliverable
************************************************
I have been reading various things about shift key operation which have
confused me ( not difficult!)
However, having just got my TS930 going in digi mode, has caused me to look
at this in a fresh light, and I am sure there is a bug.
As described by others the TS930 ( presume other Kenwood rigs also?)the
shift keys tune the VFO in S&P mode, and the RIT in CQ, logical and
satisfactory.
The FT1000MP also tunes the VFO in S&P, but I have never been able to get
it to tune the RIT in any mode.
I have felt for some while that there were circs. where the FT *would* tune
the VFO in CQ mode, and now I know this is so. Normally on program entry it
does *not* do this but exiting from S&P into CQ via Shift Tab ( at least )
causes the VFO to be tuned.
Thus the Kenwood control seems to be consistent and to spec. However the FT
control seems to be inconsistent and ( probably) not to spec.
It would certainly be nice if the FT could be made to perform just as the
Kenwoods do; is that realistic? otoh Am I missing summat here?
73
Clive
GW3NJW
Written Thu, 01 Jul 1999 17:42
clive_whelan@compuserve.com
clive_whelan@btinternet.com
http://www.btinternet.com/~clive_whelan
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|