Using 6.15, I noticed the same thing. The mults window didn't change until
I'd made a contact on the other mode. Not a big deal, but sorta surprised
me a couple of times.
73, Jim N9JF op W9SMC
> I don't know if it is only in this contest, maybe others found the same
>problem. When switching back and forth from cw to phone I find it easier to
>just keep one in VFO A and the other in the VFO B. When switching back and
>forth the program would follow everything except the mults needed would
>not, I found if I hit ALT-M twice and cycle the program through it, the
>mults needed window would then change.
> Perhaps once it even logged a Q as a new multi, that should not have been,
>when the mults needed windows was not switched, I noticed it when I did it,
>but did not have time to double check. I have not looked back in the log to
>see if it did or not.
>I will play with the log tomorrow, and run all of the reports, and see what
>it says.
>Anyone else notice this? Or does everyone else do things
>differently.
>
>Mike...NO6X
>
>
>
>Check out my home page at http://home.inreach.com/no6x
>
>--
>FAQ on WWW: http://www.contesting.com/trlogfaq.html
>Submissions: trlog@contesting.com
>Administrative requests: trlog-REQUEST@contesting.com
>Problems: owner-trlog@contesting.com
>Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
>
>
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|