When I load the program it keeps the last radio information. For
instance if I have the radio on 20CW and I last worked 40 cw it still
says 40 cw. It does not update the band and frequency until I send a
cq or do some other action and not always then. I tried a dummy qso
and it actually logged the qso as 40 cw when it was made on 20cw.
In addition if I change the band after it is correct the indication
does not change until I do some transmitting.
Has anyone else seen this behavior and if so how did you correct it?
Obviously this is not acceptable and the log could get really messed
up.
I am using a Kenwood TS870S and all connections are wired through on
the cable including pin 7 except pion 4 which is the CW keying.
Obviously it seems to me that you can't wire that one through and
still use it for CW keying.
Computer Radio
1----------------------1
2----------------------2
3----------------------3
4------------------------------------------To interface
5----------------------5
6----------------------6
7----------------------7
8----------------------8
9----------------------9
I also tried as above except
7 7---|
8 8---|
With the same result
--
Gil Baron W0MN gbaron@sparc.isl.net
http://www.geocities.com/Yosemite/Trails/4168/
Bailar es vivir" pgp2.6 key http://www-swiss.ai.mit.edu/~bal/pks-toplev.html
"Cuatro caminos hay en mi vida. Cual de los cuatro sera el mejor"
[Posted with Agent 1.5. For info, email agent-info@forteinc.com.]
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|