With fence building this weekend, I only played a few hours in ARRL DX.
Wanted to use features I haven't really tried and found the following:
Was using the bandmap with packet. ( Great feature Tree!) It was really fun
to use!
Question:
In 2 radio mode I see that if a packet spot hits the band map you can CTRL/
Page Down, pick the spot, QSY rig and work them and then hit the HOME key and
get back to your run freq. In 1 radio mode this feature doesn't seem to
work? You have to use CTRL / Page Down again and select your "CQ ***" spot
and QSY back to where you were. Am I missing a quicker way to do this or is
it only available using 2 radios?
Always learning.....
mike k5nz
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|