Doesn't make a lot of sense Cort. If the antenna is actually 50 ohms
where you want it, than any length of 50 ohm coax should work fine.
RG8, Rg8X, RG213 are all 50 ohms plus on minus 1 or two ohms. To repeat
a few previous questions, what is the balun, are you testing at high or
low power, and what length coax do they call for?
73
Hal
On 9/9/2013 4:24 PM, Courtney Judd wrote:
> ok antenna gurus what did i do wrong? originally the swr on this 4 el
> Hygain 6 mtr beam was a perfect 1:1 at 50.1 . But I wanted to run high
> power thru it so the manual calls to change the coax balun from rg58
> to rg213 which i did except I think that the coax was RG8. It was cut
> to the same length as the 58 as per the manual. Now the swr at 50.1 is
> 2:1 and the resonant point for 1:1 is clear up at 52.0 . I don't want
> to change the element lengths as they should be right on. Only thing
> else is move the beta match in or out some.... or match it some other
> way. Would the 213/rg8 make that kind of difference? Maybe I should
> change the length of that coax! Ideas? help!!!! lol, Cort K4WI
>
>
> _______________________________________________
> SECC mailing list
> SECC at contesting.com
> http://lists.contesting.com/mailman/listinfo/secc
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.contesting.com/pipermail/secc/attachments/20130909/95d377d5/attachment.html>
|