Got an email from the ARRL contest folks telling me that my log for the
December 10 meter contest was bad, with the QSO number for all non-US
stations set to zero.
Looking back in the archives of this list, I saw that a fix had already
been published on Dec 15, changing the last line in the template:
The last line reads
MAP :59 10 74 'Exchange Rcvd
It should read
MAP :54 10 74 'Exchange Rcvd
I had run the contest with SD version 10.06, and looking at the template
I saw that the last line was already set to the suggested value.
Re-running SDCHECK produced another log with the same problem.
Maybe I'd seen the fix, installed it, re-ran SDCHECK, submitted the log
without looking at it, and completely forgotten about the whole thing.
I just downloaded SD version 10.11, and re-ran SDCHECK to produce the
Cabrillo log. SDCHECK has now been running for a very long time, and
after answering the questions, it's just sat there, slowly counting down
from 30 to 1, over and over.
Any suggestions, other than forgetting about the 10 meter contest for 2012?
--
Bert Hyman bert@iphouse.com St. Paul, MN
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|