Hi all,
On a new PC, I recently installed SD 14.17 along with a new USB/RS232 cable.
I also run a Winkey USB for CW keying.
After issuing a "PORTS" command I can enter a COM port from 1 to 24 for CW
but cannot go above COM 9 for the radio control ports.
SD only seems to allow one character entry for radio ports but allows two
for CW - hence only COM ports 1 through 9 can be used for radio control
(despite SD offering COM 1 to 24). Unfortunately my USB/RS232 for rig
control is COM 11.
I am sure I am doing something stupid as I am sure this used to work in
earlier versions.
73
Allan
GM4ZUK
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|