---- Original Message -----
From: <Pa0jnh@cs.com>
> I now use a FT2000, in stead of the FT1000MP MK V, with the SD and SDX
> programs. This transceiver has all HF bands and 50 MHz.
> I have used the FTDX9000.SD as interface. I did not find
> a FT2000.SD interface. Will that come?
Yes, I'll add a separate control file for the FT2000. The
fact that it's working with the FTDX9000 file shows that the
two rigs have similar, if not identical, comms parameters.
> A. My results:
> 3. Band indicator (in edit line, where you enter a new QSO)
> does not show 6m, other bands are ok.
SDX (but not SD) should show 6m. I'll check this.
> The mode below the edit line will show CW or SSB. Other modes
> (e.g. AM or FM) are not shown.
SD and SDX provide direct support for CW and SSB only.
> To get the communication running I had to set the RTS in
> the FT2000 to OFF via Menu: 029 CAT RTS.
Thank you for the information - I'll add it to the manual.
> It sometimes (not often) happens that the frequency display
> in the SD-programs stops.
> It seems that there are two ways to stop the read-out by
> the SD program. One normal stop and one unxecpected stop
> e.g. due to a wrong answer of the transceiver. In that case
> the SD program does not automatical do a retry after an
> initialisation of the serial channel. It seems that a part
> of the program comes in a dead loop.
Please let me know if this ever happens with V13.09? I did
some work on this recently and hoped that it was fixed, but
perhaps not :-)
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|