Dear Paul,
I used SD 11.07 as my active version
Type 11, general
for the ORIGINAL QRP ctest recently.
(it requires rx:
rst-serials-class(qrp/qro/mp/vlp) and prefixes should be marked for
the evaluation by the team;
no points need to be calculated)
Logging was vy OK. I liked the position of the cursor
within the rst after the second figure to quickly change outgoing and
incoming rst.
There is enough space to write the in-characters:
rst-serial-class and even parts of the name or notes/ e.g.IOTA nbr.
The prt file shows that all.
My question:
cabrillo does not fully display it.
"Q" could be QRP or QRO.
Is 'the rest' hidden in cabrillo??
Will all be sent a s t y p e d in to the ctest managers
nevertheless?
I can edit it anyway and even add the country- prefixes after the
ctest.
Will that be sent then as well or is cabrillo restricted to the shown
characters/figures
due to the set-up ?
Is there a better set up for the OQRP where this all plus the DXCC
pref. will also be displayed
(without even calculating points)?
cabrillo:
QSO: 7000 CW 2005-07-02 1516 DL2BQD 559 001 DF9DX
559 006Q
print file, DF, TA edited manually:
02-Jul-05 1516 7 CW DF9DX 559 001 559 006QRP DF
03-Jul-05 0847 14 CW TA3BN/0 599 052 599 QROAS154 TA
I sent in my edited prt. file showing exactly all entries required
but they wanted to have a cabrillo version or an STF one.
Thanks for your answer in advance.
72! Dieter.DL2BQD
PS there is a logging programme by DL8WAA, LM contest software
www.lm4de
which supports a lot of ctests, including OQRP,
but which is preferrably used to convert paper logs quickly into
PC logs and necessary formats for the log entry.
I wanted to avoid writing on paper and putting in all after the ctest
then.
Brrrrrr!!!
I'd like to stay with SD of course.
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|